Training Screen Creation; Screen Creation Training - Mitsubishi Electric Fatec GOT2000 Series Basic Training Textbook

6.2 Training screen creation

Add the following Base Screen No. 3 to the screen created in chapter 5.
Base Screen No. 3
Bit lamp
Turns on during
line operation (M34).
Bit lamp
Lit while the run
command is ON (M31).
[Operation of Base Screen No. 3]
1.
When the [Run/Stop] switch turns ON, the operation will start, and the lamp will be lit.
2.
As the operation gets started, the operating time starts counting. When the operation time is over eight hours, the
lamp turns ON.
6.2.1

Screen creation training

(1) Creating and setting Base Screen No. 3
(Next page)
Numerical display
Displays the operating time
of the line. (D32: hours,
D31: minutes, D30: seconds)
Bit lamp
Lit if the operating display
exceeds eight hours (M35).
Touch switch
Run/Stop switch (M31)
to activate the line
Screen switching switch
Return to Base screen No. 1
1.
Create a base screen as follows:
1.
Screen No. : 3
Screen Name: Operating time display
6.2 Training screen creation
6 - 5
6. About debug
1
2
3
4
5
6