Table of Contents
Advertisement
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
•
Set Loop ID
When the "Connection" is "FC-AL", select "Manual" or "Auto" to specify the Loop ID.
"Loop ID" is an identification number of a node in a loop.
•
Loop ID
-
Manual
When the "Set Loop ID" is "Manual", enter the Loop ID.
The Loop ID must have a value that is different from the values of all the ports
(including the host adapters) that are connected to the ETERNUS DX Disk storage
system.
The following input conditions apply:
•
0x00 - 0x7D
•
Up to 2 digit
-
Automatic
When the "Set Loop ID" is "Auto", select "Ascending" or "Descending".
•
Transfer Rate (Gbit/s)
Select the transfer speed.
-
Auto-negotiation
-
2 Gbit/s
-
4 Gbit/s
-
8 Gbit/s
•
Frame Size (bytes)
Select the frame size of the target port.
"Frame Size" specifies the length of the communication information.
-
2048
-
1024
-
512
→ A confirmation screen appears.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
356
P2X0-1090-02ENZ0
Advertisement
Table of Contents
