Table of Contents
Advertisement
Chapter 3 Initial Setup
3.1 Initial Setup 1
3.1
Initial Setup 1
The flow of wizard operations in Initial Setup 1 is shown below.
(1) Set Storage Name
Register the name, administrator, and installation site of the ETERNUS DX Disk storage
system. Refer to
(2) Set Date and Time
Set the date/time and time zone (device location) of the internal clock in the ETERNUS DX
Disk storage system. Refer to
(3) Change Password
Change the password for the default account that is currently logged in before starting to use
the ETERNUS DX Disk storage system. Refer to
for details.
(4) Register Thin Provisioning License
If using the Thin Provisioning function, register the license here. Refer to
Provisioning License" (page 168)
(5) Register Copy License
If using the Advanced Copy function, register the license here. Refer to
Advanced Copy License" (page 202)
(6) Register SED Authentication Key
Register the SED Authentication Key to enable encryption of the SEDs. Refer to
Register SED Authentication Key" (page 588)
(7) Set Network Environment
Set the environment for the ETERNUS DX Disk storage system to communicate on the
network such as IP address and subnet mask. Refer to
Environment" (page 458)
Log out when the settings are complete. Log in again, and then proceed to
(page
If SED has been installed before registering the SED authentication key, reboot the ETERNUS
DX Disk storage system before logging in again.
"11.2.9.1 Modify Storage Name" (page 576)
for details.
42).
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
"11.2.9.2 Modify Date and Time" (page 577)
"11.2.1 Change User Password" (page 455)
for details.
for details.
for details.
"11.2.3.1 Setup Network
32
for details.
for details.
"7.2.9 Register Thin
"8.2.3 Register
"11.2.9.7
"3.2 Initial Setup 2"
P2X0-1090-02ENZ0
Advertisement
Table of Contents
