Logic Selectivity - ABB SACE Emax 2 Series Operating Instructions Manual

10 - Logic selectivity

Presentation Zone Selectivity via Link Bus is indicated as Logic Selectivity.
Setting Certain parameters can be configured in the Ekip Link configuration page:
93 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Logic Selectivity can be actuated for up to 12 of 15 actors that can be associated with Ekip Touch via Link
Bus (see Ekip Link module, page 236).
Parameters
The function enabling parameter, available from among the parameters that can be set for the protection,
must be set for each protection for which Zone Selectivity must be activated.
In this case, in addition to these parameters, Selectivity time is also activated for the setting.
Otherwise, Zone Selectivity can only be set up via the Ekip Connect software.
NOTE: all the following parameters and configurations are available via Ekip Connect, with
Ekip Link connected and on
selectivity masks are available in the Ekip Link advanced selectivity page for each actor present: the mask
allows the protections of the actors (S, I, 2I, MCR, G, D-Forward, D-Backward, S2, Gext, MDGF) that activate
the selectivity input of Ekip Touch to be selected (example: actor 1, protection mask S= S2: selectivity S of
Ekip Touch will be active in the presence of signals S2 of actor 1).
In this configuration, if the function is enabled for S protection and is in the alarm status, the S/D-Forward
hardware block signal and the logic selectivity S bit are activated on the output; depending on the block
signals:
• if, on the input, the S/D-Forward hardware block signal and the logic selectivity S2 bit of actor 1 is
not activated, the open command is sent in accordance with the selectivity time set for S protection
• a time equal to the trip time of S protection is waited if, on the input, the S/D-Forward hardware
block signal is activated or mixed selectivity has been selected and the S2 logic selectivity bit of
actor 1 is activated (and the open command is only sent if S protection is still in the alarm status
once this time has elapsed)
NOTES:
• the output and input logical selectivity bits are those in the data packets shared by the trip
units via Link Bus
• the S/D-Forward (G/D-Backward) hardware output is only activated if the S or D-Forward
(G or D-Backward) protections are in the alarm status, and the S/DForward (G/D-Backward)
hardware input only acts as a block for the S and D-Forward (G and D-Backward) protections,
regardless of whether solely hardware or mixed selectivity has been selected
IMPORTANT: if solely hardware selectivity has been selected, the logic selectivity bits
are ignored on the input, but are still activated on the output
Selectivity masks
Remote Programmable States A and B are also included in the selectivity masks: these 2 parameters,
which are available in the Ekip Link configuration page, enable the event (or combination of several events)
and reference actor that activates the selectivity input to be selected.
2 further states are available, C and D , but they cannot be configured for Zone Selectivity. All 4
programmable states are used for the Programmable Logic function (see Ekip Link module on page 236).
NOTE: the Programmable Logic function is independent from that of Zone Selectivity
ABB | SACE Emax 2
Ekip Touch - Protections
10 - Logic selectivity