Ekip Touch - Settings; Main Settings - ABB SACE Emax 2 Series Operating Instructions Manual

Ekip Touch - Settings

1 - Main settings

Foreword All the following parameters are available either directly, or from the Settings menu, in the conditions
Bluetooth Low Energy -
Connection security
130 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
established by Ekip Touch on the basis of the version and configuration described.
To correctly address parameters which are present in the menu but not described below:
• Circuit-breaker: Hardware Trip, T Protection, Neutral Protection
• Phase Sequence
• Monitor time
• Power Controller
• Load Shedding
• Network Analyzer
• Datalogger
• Dual Set
• Functions
please consult the Settings menu overview (page 49).
WARNING! changes to the settings must be made in the absence of protection alarms
The Bluetooth antenna on the Trip unit can be activated in the Bluetooth Low Energy menu. This is useful
for launching a communication with an external device (tablet, smartphone) according to the Bluetooth
Low Energy protocol, via the EPiC APP (page 14).
Activation of Bluetooth Low Energy communication requires the Trip unit to be pre-engineered for a
wireless connection: security of the data and Bluetooth Low Energy connection between the Trip unit
and its device is guaranteed thanks to the ABB EPiC application and the pairing configuration described
in the next paragraph.
WARNING! It is the customer's sole responsibility to provide and continuously ensure a
secure connection between his device and the Trip unit. The plant manager must establish
and maintain appropriate measures (such as but not limited to the installation of malware
prevention systems, application of authentication measures, his own system and interface
against any kind of security breach, unauthorized access, interference, intrusion, loss
and/or theft of data or information. ABB and its affiliates are not liable for damages
and/or losses related to such security breaches, unauthorized accesses, interference,
intrusion, loss and/or theft of data or information, use of APPs other than those allowed.
ABB recommends a few general configurations to strengthen the access of data into the Trip unit:
• activate the access PIN code in the Trip unit configure it with a value differing from the default value
• if parameters need not be written, configure the Trip unit only for parameter readout via bus ( Test
bus parameter = Off )
• switch off the Bluetooth Low Energy antenna ( Bluetooth Low Energy-Enable parameter= Off ) after use
IMPORTANT: communications via wireless and via service connector function alternatively:
if Bluetooth Low Energy is activated there can be no communication with other accessories
via the service connector
ABB | SACE Emax 2
Ekip Touch - Settings
1 - Main settings