Optional) Installing Outdoor Unit Communications Cables - Huawei NetCol5000-A050 User Manual

NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual
Figure 4-84 Installing power cables for the low temperature component
(1) Power cable between the
outdoor unit and the indoor
unit
Step 2 Connect one end of the 2 x 1.5 mm
component to terminal L/N on the QF2 of the outdoor unit, and connect the other
end to terminal L/N on the low temperature component or water-cooled module
of the indoor unit.
Step 3 Secure the cable on the post of the cabinet with cable ties.
----End
4.9.6 (Optional) Installing Outdoor Unit Communications
Cables
This operation is required only when the outdoor unit is equipped with a
temperature control intelligent monitoring board.
Procedure
Step 1 Route the cable through the cable hole on the top or at the bottom of the cabinet.
Step 2 Connect one end of the cable to points 1, 2, and 3 on the external signal port
X302 of indoor unit and the other end to ports 1, 2, and 3 on the outdoor unit.
Issue 13 (2023-08-20)
NO TE
The label is "Receiver heater/Water-cooled module" or "Low temperature component/
Water-cooled module". The actual label may vary.
Copyright © Huawei Digital Power Technologies Co., Ltd.
(2) Power cable between the
low temperature component
and the outdoor unit
2
power cable for the low temperature
4 Installation
(3) Top cable hole
119