NorthStar 958 Operator's Manual page 23

Chapter 1 - Getting Started
To move your vessel to a simulated position, press the
CURSOR PAD to move the cursor to the desired position and
press the DEMO POSITION key. To start demo mode at this
new position, press the ENTER key. Your vessel symbol will
now be stationary at this position.
To travel from here to a new cursor location, press the
CURSOR PAD to move the cursor to the desired position, then
press the DEMO COG/SOG key. To set your vessel's speed, use
the KEYPAD to enter the desired speed, then press the ENTER
key to start going to the demo cursor location.
To go back to the CHART screen (but stay in demo mode),
press the RETURN key twice. The word DEMO always appears
on the CHART screen when you're in demo mode.
To exit demo mode, on the DEMO CHART screen, press the
EXIT DEMO key. This immediately returns you to the CHART
screen.
NOTE:
Video image display, simulated radar image, chart rotation, and zooming
DEMO CHART
in and out all work normally on the screen.
958 Operator's Manual, Rev. A Page 15