NorthStar 958 Operator's Manual page 110

Chapter 7 - Understanding the Routes Function
Page 102
Adding waypoints to the beginning of a route
To add waypoints to the beginning of a route:
1. Press the CURSOR PAD to move the cursor onto the first
waypoint in the route.
2. Press the ADD TO FRONT menu key, then move the cur-
sor to the existing waypoint or other location that you
want to add to the beginning of the route. As you move
the cursor, the 958 displays the new route leg as a dotted
line from that first waypoint to the cursor position.
3. If you've selected an existing waypoint, press the ADD
WAYPT menu key. If you've selected only a cursor posi-
tion, press the ADD NEW WP menu key (in this case, this
waypoint is stored with a name similar to (0001), with the
parentheses indicating the waypoint is part of a saved
route and the four-digit number uniquely identifying
each waypoint).
4. Repeat these steps for each new waypoint or cursor loca-
tion you want to add to the beginning of the route.
5. When done, to add waypoints to the middle or end of a
route, press the CANCEL ADD menu key. To go to
list-based editing, press the RETURN menu key. To go
back to the CHART screen, press the CHART key.
958 Operator's Manual, Rev. A