NorthStar 958 Operator's Manual page 154

Chapter 11 - Alarms, TideTrack, and Video Display
YOUR ANCHOR
MAY BE DRAGGING
Page 146
There are two types of alarms:
•
"Auto-clear" alarms - These automatically clear after the
alarm condition disappears, or in some cases, after a short
time-out period (typically about 10 seconds). Most alarms
are auto-clearing; however, they can also be manually
cleared, if desired.
•
Alarms that require manual clearing - These will stay
onscreen until you clear them on the ALARMS screen.
All of the 958's alarms are described in Table 6 below.
The following abbreviations are used in Table 6.
For alarm message, 'NAME' = name of waypoint.
For "must be cleared,", N = no, Y = yes
Table 6: 958 alarms
Vessel has moved outside the radius limit
ANCHOR
set in the
shown only if you've turned it on at the
ALARMS
screen and you have pressed
DROP ANCHOR
the
NOTE:
alarm. This alarm is
key.
Does not time out.
958 Operator's Manual, Rev. A
Y