Appendix 2
This section describes the I/O signals for the CPU module. The I/O signal assignment for when the start I/O number of the
RJ71GN11-T2 is "0" is listed below.
List of I/O signals
The following table lists I/O signals. The device X is an input signal from the RJ71GN11-T2 to the CPU module. The device Y
is an output signal from the CPU module to the RJ71GN11-T2.
Input signals
Device number
X0
X1
X2
X3
X4 to XE
XF
X10 to X1F
Output signals
Device number
Y0 to Y1F
Do not use (turn on) any "use prohibited" signals as an input or output signal to the CPU module. Doing so
may cause the programmable controller system to malfunction.
I/O Signals
Signal name
Module failure
Own station data link status
Use prohibited
Other stations data link status (use prohibited in a local station)
Use prohibited
Module READY
Use prohibited
Signal name
Use prohibited
APPX
239
Appendix 2 I/O Signals
A