Refresh Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

Refresh Settings

Assign link refresh ranges between the devices described below.
• SB, SW of the RJ71GN11-T2  Module label of the CPU module
• SB, SW, link devices (RX, RY, RWr, RWw, LB, LW) of the RJ71GN11-T2  Devices of the CPU module
Setting method
The procedure for the refresh settings is shown below.
1.
Set the required items.
2.
Click the [Apply] button to finish the refresh settings.
Setting items
Item Description
Device Assignment Right-click in the setting window and select a link device assignment
Method method from the "Device Assignment Method" menu.
• Start/End: Enter the start and end numbers of link devices.
• Points/Start: Enter the numbers of points and start numbers of link
devices.

Link Side Set the link refresh ranges of the link special relay (SB) and link special
register (SW). One range can be set for each SB and SW. ( Page 29
Link refresh)
Ex.
00000H
·
001FFH
00000H
·
001FFH
CPU Side
RJ71GN11-T2
(1) Module label
(1)
SB
00000H
SW SW
001FFH
RCPU
Setting range
• Start/End
• Points/Start
(Default: Start/End)
■Device Name
• SB (fixed)
• SW (fixed)
■Points
• SB: 16 to 4096
• SW: 1 to 4096
(Default: 4096)
■Start
• SB: 0H to FF0H (set in increments of 16 points)
• SW: 0H to FFFH (set in increments of 1 point)
(Default: 00000H)
■End
·
• SB: FH to FFFH (set in increments of 16 points)
• SW: 0H to FFFH (set in increments of 1 point)
(Default: 00FFFH)
■Target
• Module Label
• Specify Device
(Default: Module Label)
■Device Name
• Module Label: 
• Specify Device (link side is SB): SB, M, L, B, D, R, ZR,
RD
• Specify Device (link side is SW): SW, M, L, B, D, R, ZR,
RD
(Default: Grayout)
■Points, End
• Module Label: 
• Specify Device: Displayed according to setting of
"Start".
(Default: Grayout)
■Start
• Module Label: 
• Specify Device: Device range of CPU modules (Set bit
devices in increments of 16 points and word devices in
increments of 4 points.)
(Default: Grayout)
2 PARAMETER SETTINGS
2.3 Basic Settings
2
99