17.
Set "To Use or Not to Use the Safety Communication Setting" to "Use".
[Navigation window] [Parameter] [Module Information] [RJ71GN11-T2] [Basic Settings] [Safety
Communication Setting] [To Use or Not to Use the Safety Communication Setting]
18.
Select "Local Network" from "Communication Destination" in "Safety Communication Setting" window and set the
destination module in "Select the target module for the Safety Communication Setting" window.
[Navigation window] [Parameter] [Module Information] [RJ71GN11-T2] [Basic Settings] [Safety
Communication Setting] [Safety Communication Setting] [Detailed Setting]
19.
Set the safety communication setting as follows.
20.
Click the [Apply] button.
21.
Write the set parameters to the Safety CPU on the master station.
[Online] [Write to PLC]
22.
Visually check if the safety communication setting is correctly written after writing parameters. For how to check the
parameters, refer to the following.
GX Works3 Operating Manual
23.
Reset the CPU modules or power off and on the system.
3.3 Communication Example of Safety Communication
3 PROGRAMMING
151
3