Basic Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

2.3

Basic Settings

Set the network configurations, refresh settings, or other parameters for the RJ71GN11-T2.
In this manual, "Authentication Class" is described as "CC-Link IE TSN Class".
: Can be set, : Cannot be set
Item
Network Configuration
Settings
Refresh Settings
Network Topology
Communication Period
Setting
Connection Device
Information
Slave Station Setting
Safety Communication
*1
Setting
*1 This item can be set only in a project of the Safety CPU.
2 PARAMETER SETTINGS
98
2.3 Basic Settings
Description
Set parameters of slave stations (the number of points and
assignment of link devices) in the master station.
Assign link refresh ranges between the devices described below.
• SB, SW of the RJ71GN11-T2  Module label of the CPU
module
• SB, SW, link devices (RX, RY, RWr, RWw, LB, LW) of the
RJ71GN11-T2  Devices of the CPU module
Select the network topology type according to the actual network
configuration.
Set the basic cycle setting and multiple cycle setting.
Set the CC-Link IE TSN Class of the connected device.
Set the number of consecutive communication failures until a
slave station is considered disconnected.
Set whether to use the safety communication or not and set the
safety connections and the transfer ranges of safety devices.
Availability
Master Local
station station
 
 
 
 
 
 
 
Reference
Page 117 "CC-Link IE TSN
Configuration" Window
Page 99 Refresh Settings
Page 102 Network Topology
Page 102 Communication
Period Setting
Page 104 Connection Device
Information
Page 104 Slave Station
Setting
Page 104 Safety
Communication Setting