Cc-Link Ie Tsn Configuration" Window; Parameter Setting Of A Slave Station - Mitsubishi Electric MELSEC iQ-R Series User Manual

2.5

"CC-Link IE TSN Configuration" Window

Perform the parameter setting of slave stations, the detection of connected/disconnected devices, or others.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Basic Settings]  [Network
Configuration Settings]  [Detailed Setting]

Parameter setting of a slave station

Set parameters of slave stations (the number of points and assignment of link devices) in the master station.
1.
Select the module in "Module List" and drag it to the list of stations or the network map.
List of stations
Network map
2.
Set the required items.
3.
Check the system configuration.
[CC-Link IE TSN Configuration]  [Check]  [System Configuration]
An error or a warning message appears on the output window, refer to the following.
 MELSOFT Navigator MessageNo.
4.
Select [Close with Reflecting the Setting] and close the "CC-Link IE TSN Configuration" window.
Setting items
• Simple Display: Click the [Simple Display] button to display a narrow portion of items. Use for operation with default settings
or the minimum required settings. (Default)
• Detailed Display: Click the [Detailed display] button to display all items.
Simple Detailed Description
display display
Mode Setting The settings for "Module Operation Mode" and "Communication Mode" is
displayed.
For details on the settings, refer to the following.
• Module Operation Mode: Page 111 Module Operation Mode
• Communication Mode: Page 110 Communication Mode

Assignment Select a link device assignment method.
Method • Points/Start: Enter the numbers of points and start numbers of link devices.
• Start/End: Enter the start and end numbers of link devices.
Drag and drop the text.
Setting range

• Points/Start
• Start/End
(Default: Points/Start)
2 PARAMETER SETTINGS
2.5 "CC-Link IE TSN Configuration" Window
2
117