Setting Parameters; Basic Settings; Chapter 2 Parameter Settings - Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual

2
PARAMETER SETTINGS
This chapter describes the parameter settings required for communications between the Ethernet-equipped module and
external devices.
2.1

Setting Parameters

1.
Add the RJ71EN71 in the engineering tool.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]
2.
The basic setting and application setting are included in the parameter settings. Select one of the settings from the tree
on the window shown below.
[Navigation window]  [Parameter]  Target module  [Module Parameter]
3.
After setting parameters, click the [Apply] button.
4.
Write the settings to the CPU module using the engineering tool.
[Online]  [Write to PLC]
5.
The settings are reflected by resetting the CPU module or powering off and on the system.
*1 Addition of the module is not required when using the Ethernet function of the CPU module (built-in Ethernet port part).
2.2

Basic Settings

Set the own node settings, CC-Link IEF Basic Setting
Setting items
Own Node Settings
*1
CC-Link IEF Basic Setting
External Device Configuration
*1 This setting is displayed only for modules supporting CC-Link IE Field Network Basic.
* 1
*1
, and external device configuration of the Ethernet-equipped module.
Description
Set the IP address and communication data code of the Ethernet-equipped module.
Set the network configuration settings and refresh settings of CC-Link IE Field
Network Basic.
Set the method and protocol used for communicating with external devices.
Reference
Page 242 Own Node Settings
CC-Link IE Field Network Basic
Reference Manual
Page 244 External Device
Configuration
2 PARAMETER SETTINGS
2.1 Setting Parameters
2
241