Test Equipment - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
The MTS Site Controller has the following modes of operation:
•
•
•
The MTS Base Radio has the following modes of operation:
•
•
•
Each of these modes contains a different set of Man Machine Interface Commands, which
are described in the "MTS Interface Commands" booklet.

Test Equipment

Table 6-1 lists the recommended test equipment for the Equipment Cabinet proce-
dures. Equivalent equipment is acceptable.
6802800U74-N September 2009
BOOT1 - to access this mode, interrupt the booting process by pressing the
ESC key or Ctrl+C combination when the appropriate message appears. A
password may be required to enter this mode.
Test Application - to access this mode, type the testapp command when in the BOOT1
mode. To return to the normal Site Controller Application, type reset -oplatform
command. This action reboots and resumes the normal operation.
Site Controller Application - if the boot process is not interrupted, this
is the default mode of operation.
BOOT1 - to access this mode, interrupt the booting process by pressing the ESC key or Ctrl+C
combination when appropriate message appears. A password may be required to enter this mode.
Test Application - to access this mode, type the testapp command when in BOOT1
mode. To return to the normal Base Radio Application, type reset -oplatform
command. This action reboots and resumes the normal operation.
Base Radio Application - if the boot process is not interrupted, this is
the default mode of operation.
The Test Application mode is a powerful mode. Inappropriate use of
the Test Application MMI can lead to a permanent hardware failure.
Please proceed with extreme caution.
Ensure that the test equipment is connected to the same ground system as the
equipment under test before any other connections are made to the test equipment.
Test Equipment
6-3