Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 266

Reinstalling the Post Filter
Procedure 7-14 How to Reinstall the Post Filter
1
2
3
4
5
6
7
Procedure 7-15 How to Update the Mapping List with the New TrackerID
1
2
3
4
5
6
7-28
Fasten the Post Filter onto the bracket with screws.
Slide the Post Filter into the cabinet.
Tighten the two fastening screws at the front to secure the mounting bracket.
Attach the antenna and the TX and signal cables.
Slide on the top rear and front panels and fasten these with screws.
Put the front panel back on and screw this into place.
Put the door of the cabinet back on.
Log in to the Site Controller.
Use the following MMI command to view the mapping list:can check_mapping
See example below:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
On the list, locate the unit that you have removed and that is indicated as Units are not
present.
Delete old CAN Bus unit from the CAN Bus unit mapping list. Use can remove_mapping
<Device>, where <Device> is the old unit name. See example below:
SC> can remove_mapping dpm 2
Add new CAN Bus unit to the CAN Bus unit mapping list.
The new unit Track ID is present on the replaced unit label and indicated as Track
ID not mapped in the list shown in
Use can add_mapping <Device> <TrackID>, where <TrackID> is a TrackID of
the new unit and <Device> is the new unit name: dpm X, where X denotes a digit between 0
and 3). See example below:
SC> can add_mapping dpm 2 JTH0500102
View the updated mapping list using the can check_mapping command and check that
there are no units labelled as Track ID not mapped or Units are not present.
Chapter 7: Radio Frequency Distribution System
step 2.
6802800U74-N September 2009