Mts - Checking The Inventory In Kvl; Mts - Downloading Ki's From Kvl To The Site Controller/Brc - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

MTS - Checking the Inventory in KVL

Procedure 8-19 MTS - How to Check the Inventory in KVL to Ensure Cor-
rect Information is Downloaded
On KVL select LIST, then VIEW. This information will show the sites than need Ki to be
1
uploaded.
If connecting the KVL locally to the AuC then disconnect and travel to site.
2
If connecting remotely to AuC then once the call has been dropped and the KVL displays a
3
successful download disconnect the KVL from the GSM.
Continue to
4

MTS - Downloading Ki's from KVL to the Site Controller/BRC

Procedure 8-20 MTS - How to Download Ki's from KVL to Site Controller/BRC
Connect to the Site Controller and log in as normal (Field).
1
Switch on the KVL.
2
Verify the BAUDR is set to 19200 by scrolling along to CONFIG > BAUDR and ensure it
3
is set to 19200.
On the SC type the command KVL and press Enter key.
4
5
Disconnect the PC from the Site Controller and connect the KVL to the Site Controller.
On the KVL, select UPDATE > SwMI > Ki.
6
The KVL will display UPDATING TARGET UNIT, followed by UPDATE WAS
7
SUCCESSFULLY COMPLETED.
If the KVL displays TARGET UPDATE FAILURE then this could be due to the site ID being
8
different to that in the KVL, incorrect BAUDR settings or cable problems (check all).
Disconnect the KVL and connect the serial cable to the PC.
9
Remove the lead from the Site Controller and plug into the new BRC.
10
Log in to the new BRC as Motorola and type the command KVL.
11
Within 60 seconds disconnect the test lead from the PC and plug into the KVL device and repeat
12
step 6
Upon completion of downloading Ki's to new BRC's, reconnect PC to the Site Controller and
13
enter reset to reset the Site Controller.
6802800U74-N September 2009
"MTS - Downloading Ki's from KVL to the Site Controller/BRC" on page
Remember to Ki redundant Site Controller as well as active. Only new/replaced BR should be Ki'd.
Both: step 5 and
through step 9.
step 6 have to be completed within 60 seconds.
MTS - Checking the Inventory in KVL
8-37.
8-37