Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 448

How to Install
Procedure 15-4 How to Add an Additional Base Radio to MTS 4
1
2
3
4
15-18
Remove the Blind Plate where the additional Base Radio is to be added.
Label all Rx cables with labels included in the expansion kit.
Attach the Rx cables to the filters. Connect them according to the scheme below:
Part no
#
15 3066543B02 RX cable
16
17
If Base Radio to be added is BR2, replace BR# with BR2 i table above, and so on.
Index numbers in table above refer to cable connections shown in
Figure 15-10.
At this stage only connect the cables to the filters.
Attach the Tx cable to the Tx input of the Cavity Combiner according to the scheme below:
# Note
11
If BR2
12
If BR3
18 If BR4
Index numbers in table above refer to cable connections shown in
Figure 15-10.
At this stage only connect the cable to the Cavity Combiner (ATCC or MTCC).
La-
Cable type
bel
Rx1
Rx2
Rx3
Part no Cable
type
3066543B08
Tx cable
3066543B08
Tx cable
3066543B08 Tx cable
Chapter 15: Expansion Options
From To
Filter 1 / BR# BR# / Rx1
Filter 2/ BR# BR# / Rx2
Filter 3/ BR# BR# / Rx3
Figure 15-9
From To
CC1 / TxB BR2 / Tx
CC2 / TxA BR3 / Tx
CC2 / TxB BR4 / Tx
Figure 15-9
6802800U74-N September 2009
and
and