Mts - Configuring Can Bus - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
MTS - Configuring CAN Bus
Procedure 8-13 MTS - How to Configure CAN Bus
Log in to the Active Site Controller.
1
Use the following MMI command to view the mapping list:can check_mapping
2
See command example below:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
Result: On the list, all the units will be indicated as Track ID not mapped.
Delete any units indicated as Units are not present from the CAN bus unit mapping
3
list. Use can remove_mapping <Device>, where <Device> is the unit name. See
example below:
SC> can remove_mapping dpm 2
Add all CAN bus units indicated as Track ID not mapped to the CAN bus unit mapping
4
list.
Use can add_mapping <Device> <TrackID>, where <TrackID> is a TrackID of the
new unit and <Device> is the new unit name. Units have the following names: psu X, dpm X,
atcc X, where X denotes a digit between 0 and 3. See example below:
SC> can add_mapping dpm 2 JTH0500102
View the updated mapping list using the can check_mapping command and check that there
5
are no units labelled as Track ID not mapped or Units are not present.
Proceed to
6
6802800U74-N September 2009
Units not present should only be deleted if they are old mapped devices that have
been replaced.
The unit Track ID is present on the unit label on the front panel.
Procedure 8-14, "MTS - How to Configure the Cooling Fans," on page
MTS - Configuring CAN Bus
8-34.
8-33