Base Radio Startup Sequence
Base Radio Startup Sequence
The following procedure describes starting the base radio controller (BRC) and using
test software resident in the BRC flash memory.
Procedure 6-2 Base Radio LED Verification
1
Table 6-5
Status
off
off
Amber
Green
Green
Green
Table 6-6
Status
off
off
Amber
Green
6-14
Verify the following LED conditions on the base radio controller according to
Base Radio LEDs: Normal Startup Sequence
Tx
(Transmit)
Alarm
off
off
off
Red
off
Red
off
Red
off
off
Green
off
Base Radio LEDs: Hardware Failure
Tx
(Transmit)
Alarm
off
off
off
Red
off
Red
off
Red
Refer to the Controls and Indicators section in the
conditions relating to the LEDs listed above.
Description
No power / initial
LED test (flashing multicolor)
Booting
Waiting for SWDL – this is where the BR will wait if no Site
Controller is present.
BRC main application is running
No active alarms
BR is keyed
Description
No power / initial
LED test (flashing multicolor)
Booting
Waiting for SWDL – this is where the BR will wait if no Site
Controller is present.
BRC main application is running but an alarm is preventing the BRC
from keying
Chapter 6: Configuration and Testing
Chapter 10, "Base Radio"
6802800U74-N September 2009
Table
6-5.
for