MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Hybrid Combiner in MTS 2
The Hybrid Combiner is a part of the transmitter path in the RF Distribution System. The Hybrid
Combiner provides very reliable combining of up to two transmitters. The Hybrid Combiner
has no limitations in respect to channel spacing of the TX channels, however for frequency
planning and interference reasons at least 50kHz is recommended.
Figure 7-9 Hybrid Combiner
The TX signals from two Base Radios are attached to the respective Hybrid Combiner inputs. The
combined signal at the Hybrid Combiner outport port is then applied to the Duplexer.
The Hybrid Combiner contains one printed circuit board.
FRU Replacement Process
For a list of available FRUs, see
Process 7-3 Replacing the Hybrid Combiner
Remove the Hybrid Combiner, see
1
Insert the Hybrid Combiner into the filter tray, see
2
6802800U74-N September 2009
Appendix A, "Field Replaceable Units
Procedure
7-6.
Hybrid Combiner in MTS 2
(FRUs)".
Procedure
7-7.
7-13