MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Viewing the Transmit Spectrum (optional)
The transmit spectrum can be viewed on the Spectrum Analyzer. Perform the following
procedure to view the transmitted signal spectrum.
At the Test Application prompt, type: power -otxch1 -a35
This command sets the transmitter output to maximum rated output.
Figure 6-6
Figure 6-6 Spectrum Analyzer Display of Transmitted Signal
0.0
-10.0
-20.0
-30.0
-40.0
-50.0
-60.0
-70.0
-80.0
-90.0
-100.0
-110.0
-120.0
At the prompt, type: power -otxch1 -a0
This command stops RF transmission
Repeat this procedure for each base radio.
6802800U74-N September 2009
The following command keys the transmitter. Make sure that transmission
only occurs on licensed frequencies or into a dummy load.
shows the transmitted signal on the Spectrum Analyzer.
Frequency, MHz
RBW = 300 Hz
Viewing the Transmit Spectrum (optional)
Span = 0.10 MHz
TEBTS062
012297JNM
6-29