MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Process 15-4 Installing 4 CH Cavity Combiner Expansion Kit
1
2
Figure 15-14 ATCC Cabling Diagram for MTS 4 with 1 TX ant. before Expansion
Procedure 15-10 How to Install Additional Cavity Combiner
1
2
3
6802800U74-N September 2009
Install the new Cavity Combiner into the cabinet, see
Additional Cavity Combiner," on page
Update the mapping list with the new unit TrackID, see
Mapping List with the New TrackerID," on page
The cavity Combiner can weigh up to 11.8 kg (26 lbs.). Use caution when
removing or installing Cavity Combiner into the equipment rack. Make
sure the combiner is fully supported when free from mounting rails to
avoid injury to personnel and equipment damage.
Only applies for Auto Tuned Cavity Combiner (ATCC).
Switch OFF the Power Supply Unit.
Remove the panel in front of where the additional Cavity Combiner is to be assembled.
Assemble bracket with 3 M6x10 screws.
Procedure 15-10, "How to Install
15-35.
Procedure 7-15, "How to Update the
7-28.
How to Install
15-35