Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 301

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 8-8 MTS - How to Download the Site Controller Application (Continued)
10
11
12
MTS - Programming the BRC Application
Procedure 8-9 MTS - How to Program the BRC Application
1
2
3
4
5
6
7
8
9
10
11
6802800U74-N September 2009
You will now see a Transmission Status window showing the Site Controller application
file transfer status and when complete, verify that the transmission status result is Sent and
Configured then click OK.
To confirm that the Site Controller application is loaded into the Site Controller, type the word
attrib (short for attribute) and verify that the file you uploaded is in the bank that you chose.
Keep pressing Enter until you return to the
Continue to "MTS - Programming the BRC Application" on page
Start up the TESS application as described in
on page 8-19.
Select Send Files, select Send Application Files.
Result: The Application for Download window should open.
Using a combination of Drives and Folders menus, browse to the CD until you find the folder
entitled SWDL. Double-click swdl, double-click xfer, double-click BRC.
Result: The version of BRC application (Typically Rnn.nn.nn.brc) should now be seen in
the left hand window.
Click on the BRC version which should now appear under the File Name window and click OK.
Result: File Download Properties window should now open showing the version of BRC
application you are about to upload at the top of the window.
Change the S/W version label as required by entering a new label in the box.
This is optional and normally is left blank.
Click in the Use Next box.
Click on Update Selected Items and verify that the BRC application version at the top of the
window now has + under the Next word then click OK.
Result: If there is already an application file in both BRC bank 1 and bank 2, a window will
open prompting you to select the file that is to be replaced i.e. overwritten by the file you are
about to upload.
Select the file that is NOT currently set to Current and Next i.e. the one that is not currently
being used and generally an older file from a previous upload and click OK.
You will now see a Transmission Status window showing the BRC application file transfer
status and when complete, verify that the transmission status result is Sent and Configured
then click OK.
To confirm that the BRC application is loaded into the Site Controller, type the word attrib
(short for attribute) and verify that the file you uploaded is in the bank that you chose.
Continue to "MTS - Changing the Site Controller Configuration File" on page
MTS - Programming the BRC Application
prompt.
SC>
8-25.
Procedure 8-4, "MTS - How to Set Up a Terminal,"
8-26.
8-25