Mts - Restoring The Site Controller Software - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 8-7 MTS - How to Replace Site Controller (Continued)
At the prompt, enter status sc –all. The command displays preliminary diagnostics
12
information on the Site Controller. This includes the health of the Site Controller, the trunking
state, the internal state and the site link status.
If any device drivers are reported as failed to initialize, then this indicates a problem with that
13
peripheral. However, successful initialization of a device does not guarantee that it is fully
functional; further tests are necessary to ensure this. The above tests are carried out upon
power-up or reset. The command simply reports the last status of the test. To actually re-run the
tests, it is necessary to reset the Site Controller.
Restore the Site Controller software. Proceed to
14
on page

MTS - Restoring the Site Controller Software

Process 8-3 MTS - Restoring the Site Controller Software
1
2
3
4
6802800U74-N September 2009
Initialization procedure may be halted and restarted at any time by pressing the
RESET push button for at least 2 seconds on the Site Controller front panel.
8-23.
An assumption is made that the customer has a valid backup of the configuration.
Restore the Site Controller and BRC Application and Site Controller Firmware (see
Restoring SC and BRC Application and SC
1. Download the Site Controller application. See
Application" on page 8-24.
2. Program BRC Application.
If the Site Controller has correct version of software, go to
attrib to verify software version of the Site Controller.
Change the configuration file. See
on page 8-26.
This step applies only to security class 2 and 3 systems.
Download the Site Controller configuration. See
Configuration" on page 8-27.
Configure CAN bus. Continue to
MTS - Restoring the Site Controller Software
"MTS - Restoring the Site Controller Software"
Firmware")
"MTS - Downloading the Site Controller
"MTS - Programming the BRC Application" on page
"MTS - Changing the Site Controller Configuration File"
"MTS - Downloading the Site Controller
"MTS - Configuring CAN Bus" on page
"MTS -
8-25.
step 2. Enter command
8-33.
8-23