Configuration
Procedure 15-13 How to Assemble the Module Cage in the MTS 4 Cabinet (Continued)
5
6
7
8
Configuration
No configuration in itself is needed for the module cage, but the Power Supply Unit needs to be
configured and this is described in
Installation and configuration of additional Base Radios are described separately in
Base Radio into Existing Module Cage for MTS 4" on page
Furthermore, if an additional Site Controller is ordered as a separate expansion kit, it needs to be
installed and configured, see
Adding Redundant XHUB Controller
■
■
■
■
■
■
■
■
■
■
■
■
■
This section describes how to add an redundant XHUB Controller to an MTS 4 Expansion Cabinet.
List of Equipment in the Expansion Kit
When ordering an additional XHUB Controller, the following is included in the expansion kit.
Table 15-9 Equipment in Expansion Kit
Kit number
GMCN4646A
GMKN4691A
15-42
Connect the power supply cables and optional backup battery cables.
Connect the Ethernet cables and CAN Bus cables mounted in Step 2 above.
Switch ON the Power Supply Unit.
Check the LED indicators to verify the PSU is operating correctly.
"PSU TrackID Update" on page
"Adding Redundant Site Controller" on page
■
■
■
■
■
■
■
■
■
■
■
■
■
In order to be able to expand to a redundant XHUB Controller, a redundant Site
Controller must be present in the MTS 4 Prime Cabinet.
Description
XHUB Controller kit
Redundant XHUB cable kit
15-13.
■
■
■
■
■
■
■
■
■
■
■
■
■
■
Chapter 15: Expansion Options
11-11.
"Adding Additional
15-25.
■
■
■
■
■
■
6802800U74-N September 2009