Installing An Rs-485 Local Network Link Between Hydran 201Ci Controllers - GE Hydran 201 i Instruction Manual

9.5.1 Installing an RS-485 Local Network Link Between Hydran 201Ci
Controllers
A local network is a chain of Hydran 201i Systems and/or Hydran 201R Model i's in which
the Hydran 201Ci Controllers are connected together using an RS-485 link. If the instal-
lation includes only one Hydran 201i System or Hydran 201R Model i, go to Section 9.5.2
on page 9-10.
Proceed as follows:
1. Run an RS-485 cable from one H201Ci to the next in a conduit to form a chain. Use
instrumentation-grade cables (twisted triad with overall shield); otherwise use
armored cables.
Note: The total maximum length for all RS-485 link cables in a local network is 1,200 m
(4,000 ft).
WARNING
The shield of each cable section must be grounded at one end only.
CAUTION
2. Connect the RS-485 cables into the main terminal block. For wiring details, see
Appendix D.
Note: No wires are criss-crossed in an RS-485 link; pin 1 is always connected to pin 1,
pin 2 to pin 2, pin 3 to pin 3. Except for the two H201Ci's located at each end of a local
network, two RS-485 link cables are attached to each H201Ci using the Main Terminal
Block. Powering down one H201Ci does not affect the local network nor the other
H201Ci's.
The shield of each cable section must be grounded at one end only.
WARNING
CAUTION
Routing and shielding of the RS-485 cable is particularly important
because all H201Ci's belonging to a network share a common
reference with this link.
The operation of the complete H201Ci network may be affected if
WARNING
CAUTION
wires are not connected correctly. Be careful when installing and
inserting each wire. Be sure to insert all strands in the terminal;
strands that touch two terminals cause problems. Do not leave trims
of metallic strands inside the H201Ci's enclosure.
Part 17997 Rev. 6, March 2011
Local Network Installation
9-9