Conveyor" Window (In Debug Mode); Pcb Stpr" Tab Sheet In The "Conveyor" Window - Yamaha SIGMA-G5SII Service Information

2.6.2. "CONVEYOR" window (in Debug Mode)

Control Switch
1. Desig Width (Target Width + Clearance: mm)
2. Zeroing
3. PCB posn. lct. snsr. Tch
 These functions are not available when there is a PCB on the conveyor.
All the items are operated under the condition where there is no PCB on the conveyor.
 When an error occurs that a PCB is always detected in the display (sensor detection error)
while there is no PCB in the machine, the "PCB Positioning Detection Sensor Teaching"
operation is performed. This error occurs when the conveyor width is changed manually
during the power OFF condition in the machine delivery.

2.6.3. "PCB Stpr" Tab Sheet in the "CONVEYOR" Window

Note:
This tab sheet is used to measure each stopper operation time.
Service Information
SI1705004E-00=SIGMA-G5SII Service Manual
72/273
For Service Engineer