Cutter Unit Operation Check - Yamaha SIGMA-G5SII Service Information

4.16.4. Cutter Unit Operation Check

(1) Start up the machine and connect the feeder cart to the machine using the connectors.
(2) Select
(3) Touching the window in the order as shown in the following figure, the use of the
" Debug " window is enabled.
* Refer to the following figure for the
"Debug" is displayed and when the "Unit
Adj." is selected, the functions in the red
frame become available.
Normally, only "Noz Chng" and "Line
Meas" functions are available.
" Maint. " and " Engineer " to display the initial maintenance window.
Fig.D103
Service Information
" "
Debug display procedure.
①. Hold the section ①. down until a single green
circle appears in the area ⑥.
②. After the green circle has appeared, hold the
section ② down until three green circles
appear in the area ⑥.
③. When three green circles appear, hold the
section ③ down. Then, ④ will appear.
④. After ④ has appeared, touch the area ⑤.
The debug mode will be displayed.
SI1705004E-00=SIGMA-G5SII Service Manual
178/273
For Service Engineer