Panasonic MICRO-IMAGECHECKER PV310 Use Manual page 79

Checker Main application
Position Binary Edge
Adjustment
Gray Edge
Feature Extraction
Matching
Rotation
• Measurement of a
Adjustment
moving amount (X, Y)
Rotation
• Measurement of
Adjustment
rotation angle
• Movement of a
checker shape to the
current position of an
object
• Rotation of an
checker shape
according to the
rotation angle of the
object
Binary Edge-Horizontal
Binary Edge-Vertical
Gray Edge-Horizontal
Gray Edge-Vertical
Feature Extraction
Matching (detection
angle)
Matching (two detection
points)
Contour Matching
Description
Rotation Adjustment:
With the use of each checker function, detects the angle of the
object using the position (coordinates) of the object and
calculates the angle that the object was rotated from the base
angle. Grouped checkers are executed in the position where the
object was rotated from the base angle. But, to let each checker
refer to the adjusted angle, the number of
rotation-adjustment-referred checkers must be lower than the
number of the rotation-adjustment-referring checker. The object
can be detected following the procedures shown below.
Detects an angle on the basis of the coordinates of the two
edges that can be detected by scanning in horizontal direction.
Detects the angle on the basis of the coordinates of the two
edges that can be detected by scanning in vertical direction.
Detects the angle on the basis of the coordinates of the two
edges that can be detected by scanning in horizontal direction.
Detects the angle on the basis of the coordinates of two edges
that can be detected by scanning in vertical direction
Makes a rotation adjustment using the angle of the principal axis
detected by Feature Extraction. (+/- 90 degree angle)
Makes a rotation adjustment with the use of the Smart Matching
checker, which supports for 360-degree rotated object
Makes a rotation adjustment using the angle created by the
straight line connected to the two detection points that were
detected by executing two Smart Matching checkers and the X
axis
Makes a rotation adjustment using Contour Matching checker
supportable for 360 degree angle. Up to four Contour Matching
checkers can be set per product type (including Contour
Matching checker). This function is available only if the camera is
in Frame mode.
Refer.
Page
142
145
148
150
152
154
156
158
160
162
160
162
165
71