Table of Contents
Advertisement
7.2.8 Conversion into Actual Size Value: Conversion Data
The Conversion Data function is effective to convert the results
calculated by pixels into actual size. After capturing the scale or
slide gauge, calculate a coefficient by inputting the number of
pixels of actual size. Up to four conversion data can be stored in
the PV310.
Setting a Conversion Data
1.
Choose "ENVIRONMENT" > "Conversion Data" from the menu
bar.
2.
Highlight the number of the data that you want
to convert.
After the cursor moved to a cell in the Base Dist.
column, enter the data of base distance.
3.
Press the ENTER key to enter the data of base
distance and press the ENTER key again.
For example, when set to 10 mm, enter "10". (See
the figure shown below.)
4.
Highlight the data displayed in a cell in
the Base Pixel column.
Enter the number of the pixels
corresponding to 10 mm. Check how many
pixels are equal to 10 mm with each
checker. The example that 10 mm is equal
to 85 pixels is explained here.
5.
Enter "85" and press the ENTER key.
The coefficient is calculated and displayed.
The calculation results of numeric calculation can be copied to "Base Pixel" of the conversion data. To select
numeric calculation No., select "Calcu.-Stat.-Output" from the TOOL menu first, then select "To Conversion"
from the submenu that is displayed by pressing the B key, finally select the number of the conversion data to
which is copied.
178
Advertisement
Table of Contents
