Panasonic MICRO-IMAGECHECKER PV310 Use Manual page 325

Cause
Camera capturing error
• Connects a normal camera: ANM832 and sets D.S.Random
Frame/Field mode.
• The DIP switch setting of a D.S. Random camera does not
correspond with the camera mode selected with PV310.
E.g.)
Camera mode: D.S. Random Frame
DIP switch setting: Field (No.6 = OFF)
• Connects a D.S. Random camera to Camera port B.
• Connects a D.S. Random camera with a camera cable
incorrectly or a cable disconnected.
Problem: ERROR (error) signal is output while inspection is not performed.
Timing
When data saving
When product types were switched
When display images were switched
When the data of CF card was restored.
When a template was re-registered
When changing the binary slice level
When referring Gray Edge threshold value
When changing Gray Edge threshold
value
When referring numerical calculation
maximum/minimum value
When changing numerical calculation
maximum/minimum value
During AXTOOL communication
Relevant Error
Function Code
E0071
Error
Cause
Code
E0170 When PV310 failed to save data by serial command input
and returned error response "%Z" to the external device.
E0171 Product types were switched by specifying the number of
the product type that has not been created.
E0172 By using parallel (I/O) signal
Execution signal (FCT1/FCT2) was input by specifying an
undefined combination of IN1-IN3 or IN1 –IN7 signals.
By using serial command
E0173
When each command was input, the PV310 returned error
response "%Z" to the external device.
E0174
E0175 When serial command was input, the PV310 returned error
response "%Z" to the external device.
E0176
For more information, refer to Chapter 11.2.6 "Details of
Commands".
E0177
E0178
E0179
E0180 More than 30 seconds has passed since communication the
PV310 and external device was disconnected by removing
the Ethernet cable while the PV310 was communicating with
AXTOOL. Ver. 3.
Check and Response
Connect and set correctly. If the error
reoccurs, try the following procedures.
• Cut the power and reconnect the
camera cable.
• Replace the cable.
317