Panasonic MICRO-IMAGECHECKER AX40 User Manual page 248

Keypad Emulation (%K)
This function enables you to move the cursor and displace the start/end points without using the ENTER
key, A/B/C keys on a keypad when the AX40 receives the commands from the external device such as
PLC.
Communication direction
Sending data from
external device
Response - Normal
Response - Error
240
Command / Description
% K ? CR
? : 1 - 9, A - C
? Action
1 Move left downward
2 Move downward
3 Move right downward
4 Move leftward
5 Press the Enter key
6 Move rightward
7 Move left upward
8 Move upward
9 Move right upward
A Press the A key
B Press the B key
C Press the C key
No response to this command.
% U CR
Cause
• Command in the unspecified form or not provided was received.
Example
C
- %K01 (2-digit values are specified.)
R
Only if READY signal is on (AX40 is waiting for the signal from external device
in RUN mode), error response is send back to the external device. While the
AX40 is in SETUP mode or is executing inspection, the AX40 does not response
to this command.