Panasonic MICRO-IMAGECHECKER AX40 User Manual page 242

Command Digit: Fixed (4 Digit)
Communication Command / Description
direction
Sending Command
from External
Device
??: 01 to 99 ( Object checker No.)
aaaa: 0001 to 0255 or 0001 to 0255 (Horizontal of Edge Threshold or Base Checker
1)
bbbb: 0001 to 0255 or 0001 to 0255 (Vertical of Edge Threshold or Base Checker 2)
0001 to 0255: If invalid = 0
0001 to 0255: If invalid = space
Response - At
normal operation:
At the end of
??:01- 99 (Checker No.)
Change
aaaa: 0001 to 0255 or 0001 to 0255 (Horizontal Edge Threshold or Edge threshold
Base Checker 1)
bbbb: 0001 to 0255 or 0001 to 0255 (Vertical Edge Threshold or Edge threshold Base
Checker 2)
0001 to 0255: If invalid = 0
0001 to 0255: If invalid = space
Response: Error 1
Cause
•
Response: Error 2
ERROR signal is
output from the
Cause
parallel output port.
•
•
•
*1
• If either Horizontal or Vertical is created, specify "0" to the unset edge threshold. (If the
numbers except "0" is specified to the uncreated edge threshold, error response %Z
output). Response to the change command is "0".
• Example: checker No. 1 Horizontal- Edge Threshold: 100, Vertical: Unset
Sending Command
% G 0
Response at normal operation
% G 0
234
% G ? ? a a a
% G ? ? a a a
% U CR
Command in the unspecified form or not provided was received.
Examples:
- %G100800100 CR (any other checker number than 01 - 99 was specified.)
- %B0100800200 CR (not provided command)
% Z CR
Checker No. specified by a sending command does not include the target checker.
The edge threshold specified by a sending command is not between 001 and 0255 or 1
and 0255.
If an unset threshold is specified to the numbers except "0" when either Horizontal or
Vertical of Position Adjustment (Gray Edge) is set.
1 , 1 0 0 , 0
1 , 1 0 0 , 0
a b b b b CR
a b b b b CR
0 0 CR
0 0 CR
C
will be
R