Panasonic MICRO-IMAGECHECKER AX40 User Manual page 111

5. Move the output point (the displayed "+" mark) and press the ENTER key.
You can position the output point outside the template area. Even if the output point is placed out of the
display area, its detection position can be output. When the template area is displayed in yellow, the
template setting is completed.
Output point
Output point is the one that indicates the location of an image when the image that matches the template
was detected. After image detection, the coordinate values of this point are output to the external device.
You can place the output points the desired locations (the output points is not always positioned within the
template area.).
Setting the output point to "Middle Point".
(1) Press the B key under the condition that the position of the output point can be set.
(2) When "Middle Point" appears, press the ENTER key.
The output point moves to the center of the template area.
(3) Press the ENTER key to fix the position.
When the output point disappears and template area appears in yellow, the setting of template area has
been completed.
6. Select "Search Area".
Follow the steps for area setting (the Search Area function is set to full screen by default).
7. Select "Position Adj." and press the ENTER key.
When you make a position /rotation adjustment, set the number
You can set only the position/ rotation adjustments assigned to the lower numbers than Smart Matching.
(See page 115 for Position Adjustment and 129 for Rotation Adjustment.)
8. Set "Angle Range".
Select an angle range for searching. If specifying an angle range from 0 to 30, you can search within the
limitation of +/-30°.
Note that it will take more time for searching if you increase the angles range.
9. Set "Rot. Accuracy".
Before searching the rotation direction, set the degree by which you want to search.
Note that fine searching will be performed, if you set the Rotation Accuracy function to "0.1"; however, you
will need more time for searching.
10. Select "Sorting".
The submenu is displayed.
Sorting
This is a function that is necessary for
using the feature data of the object
(calculation, statistics, data monitor).
When multiple images are detected,
arrange them in descending or
ascending order based on
correspondence, and X- /Y-coordinate.
You can specify the number of the object
by always arranging multiple objects in
certain order.
103