Panasonic MICRO-IMAGECHECKER AX40 User Manual page 120

Hide thumbs Also See for MICRO-IMAGECHECKER AX40:
Table of Contents

Advertisement

6.10.3 Setting Procedure
1.
Proceed up to "Configure the setting for memory" at the second step following section 6.2.
Memory: Sets color extraction (group select) of an extraction image
2.
Select "Template".
3.
Select "Change".
4.
Set the range you want to resister as a base image and decide the start and end points
A sub area is displayed within the template area. Position the start and end points of the template
area within the sub area
Available template area is as follows:
Size of template area: 61440 pixels ( = 512 x 480 pixels
/ 4)
(No limitation for horizontal or vertical length.)
5.
Move the output point ("+" mark) and press the ENTER key.
When the template area is displayed in yellow, the template setting is competed.
Output point:
Indicates the location of the image when an image corresponding to the template image is detected. After
image inspection, the coordinates of this point are output. The output point can be placed on the desired
positions of the monitor screen. (You do not have to place it within the template area.)
Set the output point to Middle Point:
(1) Press the B key under the condition that the position of the output point can be
set
(2) When "Middle Point" appears, press the ENTER key. The output point moves to the center of the
template area.
(3) Press the ENTER key to fix the position.
When the output point disappears and the template area appears in green, the setting of template area is
completed.
The following messages may be displayed at template setting.
E0130 image Not has feature.
This message is displayed when the image in the template area has no or a few Features
(Contours). Check or if necessary change the settings of color extraction and monitor the
gray image and differential image. If you still cannot register the template after doing so,
adjust the size of the template area.
You can update it by receiving the input signals from the external device (or by re-registering
the current image). See page 214 for details.
112

Advertisement

Table of Contents
loading

Table of Contents