10.2.4 Switching the Display Images
Overview
You can switch the images to display on the screen by inputting a signal from the external device. The
display images can be switched by assigning the types of the images to display to IN1-3. The display
images switch is executed upon the FCT1 signal input.
Assigning the Image to be displayed
Assign the types of images to IN 1 - 3 (3 bit). Refer to the table shown below.
Timing Chart
1.
Assign the types of the image that you want to display to IN 1- 3. (Input the data more than 1
ms before FCT1 signal input).
2.
Input a FCT1 after making sure that READY signal is on.
After READY signal is turned off, the display image is changed.
3.
Make sure that READY signal is off and then turn the FCT1 signal off.
After the product type switch is completed, READY signal is turned on.
213