Huawei FusionModule1000A40 Commissioning Manual page 73

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide

The WAN_1 port IP address cannot be set to an IP address in any of the following network
segments: 192.168.0.x, 192.168.8.x, 192.168.248.x, and 192.168.245.x.

IP addresses for the WAN_1 and WAN_2 ports should not be set in the same network
segment.

In some customized scenarios, the default IP address for the WAN_2 port is
192.168.248.10. The default value prevails.

WAN ports support the Internet access and LAN ports support the intranet access. Connect
the PC network port to the WAN port or LAN port on the ECC800 based on the access
network.
Step 2 Configure the PC IP address and the WAN_1 IP address in the same network segment.
If the port IP address is 192.168.1.10, subnet mask is 255.255.255.0, and default gateway is
192.168.1.1, set the PC IP address to 192.168.1.11, subnet mask to 255.255.255.0, and default
gateway to 192.168.1.1.
Step 3 Set LAN parameters.


1.
2.
3.
4.
5.
Issue 04 (2020-01-17)
If the ECC800 connects to a LAN and a proxy server has been selected, perform
d.(Optional) On Proxy se....
If the ECC800 connects to the Internet, and the PC in a LAN accesses the Internet over a proxy
server, do not perform Step 3.3
the ECC800.
Open the Internet Explorer and choose Tools > Internet Options.
Click the Advanced tab and select Use TLS1.1 and Use TLS1.2.
(Optional) Click the Connections tab and select LAN settings.
(Optional) On Proxy server, clear Use a proxy server for your LAN.
Click OK.
Copyright © Huawei Technologies Co., Ltd.
and d.(Optional) On Proxy se.... Otherwise, you will fail to access
8 Commissioning Core Components
Step 3.3 and
67