Service - Siemens SINUMERIK 840D Description Of Functions

Hla module
Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

6 Hydraulics Diagnostics
Reaction
Remedy
To continue
program
300 710
Explanation
Reaction
Remedy
To continue
program
300 713
Explanation
Reaction
Remedy
To continue
program
6-192
SINUMERIK 840D/SIMODRIVE 611 digital Descr. of Functions HLA Module (FBHLA) – 04.00 Edition
NC not ready.
Mode group not ready.
NC Stop in response to alarm.
NC Start disable.
The NC switches to follow-up mode.
Alarm is displayed.
Interface signals are set.
Please inform authorized personnel/service engineer.
Set drive basic clock cycle to the same value for both axes.
Switch control system OFF and ON again.
Axis %1, drive %2 position controller clock cycle axially unequal
%1 = NC axis number
%2 = drive number
The position controller clock cycle is different for the two axes on a 2-axis mod-
ule.
This alarm can only occur in connection with OEM users who are using 611D
drives without the standard NCK interface. In this instance, it would be possible
to transfer different axial position controller clock cycles to the 611D module.
NC not ready.
Mode group not ready.
NC Stop in response to alarm.
NC Start disable.
The NC switches to follow-up mode.
Alarm is displayed.
Interface signals are set.
Please inform authorized personnel/service engineer.
Set position controller cycle to the same value for both axes.
Switch control system OFF and ON again.
Axis %1, drive %2 lead time for position controller invalid
%1 = NC axis number
%2 = drive number
The position controller computing time reduction specified by the NC must be
shorter than the position controller cycle. The offset must be an integral multiple
of the speed controller cycle.
NC not ready.
Mode group not ready.
NC Stop in response to alarm.
NC Start disable.
The NC switches to follow-up mode.
Alarm is displayed.
Interface signals are set.
Please inform authorized personnel/service engineer.
Correct MD 10082: CTROUT_LEAD_TIME (offset in setpoint transfer time).
Switch control system OFF and ON again.
 Siemens AG 2000. All rights reserved
02.99

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611 digital

Table of Contents