Siemens SINUMERIK 840D Description Of Functions page 191

02.99
300 701
Explanation
Reaction
Remedy
To continue
program
300 702
Explanation
Reaction
Remedy
To continue
program
300 707
Explanation
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital Descr. of Functions HLA Module (FBHLA) – 04.00 Edition
Start-up required for axis %1, drive %2
%1 = NC axis number
%2 = drive number
This alarm occurs during initial start-up when no valid 611D machine data are
available!
NC not ready.
Mode group not ready.
NC Stop in response to alarm.
NC Start disable.
The NC switches to follow-up mode.
Alarm is displayed.
Interface signals are set.
Please inform authorized personnel/service engineer.
S
Boot the motor data
S
Back up the BOOT drive
S
Power up system again
Switch control system OFF and ON again.
Axis %1, drive %2 drive basic clock cycle invalid
%1 = NC axis number
%2 = drive number
The drive basic clock cycle set on the NC is too high for the drive.
NC not ready.
Mode group not ready.
NC Stop in response to alarm.
NC Start disable.
The NC switches to follow-up mode.
Alarm is displayed.
Interface signals are set.
No remedial measures need to be taken. After the system has powered up
again, the NCK machine data relevant to the drive basic clock cycle, i.e.
MD 10050: SYSCLOCK_CYCLE_TIME (basic system cycle) and MD 10080:
SYSCLOCK_SAMPL_TIME_RATIO (scale factor of position controller cycle for
actual value sensing) are automatically altered so that the relevant limits are
applied.
Switch control system OFF and ON again.
Axis %1, drive %2 drive basic clock cycle axially unequal
%1 = NC axis number
%2 = drive number
The drive basic clock cycle is different for the two axes on a 2-axis module.
This alarm can only occur in connection with OEM users who are using a 611D
drive without the standard NCK interface. In this instance, it is possible to trans-
fer different axial drive clock cycles to the 611D modules.
6 Hydraulics Diagnostics
6-191