Operator Controls; Service And Operating Mode Switch - Siemens SIMOTION D4 Series Manual

Operation (hardware)

2.2 Operator controls

Figure 2-2
2.2 Operator controls
2.2.1

Service and operating mode switch

Properties of the Service switch and mode selector
SIMOTION D4x5-2 has two selector switches on the lower front side for selection of the
service functions and operating modes.
The upper selector switch (labelled SVC/NCK) is for the selection of service and diagnostic
functions. In "normal" operation this switch must remain in the 0 position (see figure below).
The lower switch, labelled PLC, is used to set one or more operating modes of the
SIMOTION D4x5-2.
32
Operator control and display elements of D445-2 DP/PN and D455-2 DP/PN
SIMOTION D4x5-2
Manual, 11/2010