Monitoring Functions - Siemens SINUMERIK 840D Description Of Functions

4 Firmware Drive Functions
4.13 Mounting functions
4.13

Monitoring functions

4.13.1 Alarms
Power On alarms
5600 ALARM_MASK_POWER_ON
Concealable alarms (Power On)
Bit 4: "Measuring circuit measuring system"
Bit 5: Measuring circuit absolute track
Bit 8: "Zero marker error"
Unit: Default:
HEX 0
5612 ALARM_REACTION_POWER_ON
Config. shutdown reaction to PO alarms
Bit 0= 0: No enable signal cancellation in response to
internal errors
1: Enable signal cancellation in response to internal
errors
Unit: Default:
HEX 0
5731 CL1_PO_IMAGE
Image ZK1_PO register
Unit: Default:
HEX 0
RESET alarms
5601 ALARM_MASK_RESET
Concealable alarms (Reset)
Bit 7: "Valve controller not reacting"
Bit 8: "Velocity controller at limit"
Bit 9: "Encoder limit frequency exceeded"
Bit 10: "Piston position negative"
Bit 11: "Pressure measurement failure"
Bit 12: "Force limitation OFF"
Unit: Default:
HEX 0
5613 ALARM_REACTION_RESET
Config. shutdown reaction to RESET alarms
Bit 0= 0: No enable signal cancellation in response to
configuration errors
1: Enable signal cancellation in response to
configuration errors
Unit: Default:
HEX 0
4-150
SINUMERIK 840D/SIMODRIVE 611 digital Descr. of Functions HLA Module (FBHLA) – 04.00 Edition
Minimum: Maximum:
0 FFFF
Minimum: Maximum:
0 FFFF
Minimum: Maximum:
0 FFFF
MD 5600: ALARM_MASK_POWER_ON can be set to conceal Power On
alarms. If the relevant bit is set to 0, the corresponding error monitoring function
is active. If the bit=1, the error monitoring function is suppressed. The default
setting is "active" for all monitoring functions.
MD 5612: ALARM_REACTION_POWER_ON is set to configure switchover of
the relevant Power On alarm.
For alarm messages, see Chapter 6, numbers 300500...300599.
Minimum: Maximum:
0 FFFF
Minimum: Maximum:
0 FFFF
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
UNS.WORD Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
UNS.WORD Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
UNS.WORD Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
UNS.WORD Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
UNS.WORD Immediately
 Siemens AG 2000. All rights reserved
02.99