Siemens SINUMERIK 840D Description Of Functions page 131

08.99
02.99
5285
OUTPUT_FIL_1_DAMP [n]
Damping of control output filter 1
Unit: Default:
– 1.0
5288
OUTPUT_FIL_1_SUP_FREQ [n]
Blocking frequency of control output filter 1
Unit: Default:
Hz 3500.0
5289
OUTPUT_FIL_1_BW [n]
Bandwidth of control output filter 1
Unit: Default:
Hz 500.0
5290
OUTPUT_FIL_1_BW_NUM [n]
Numerator bandwidth for control output filter 1
Unit: Default:
Hz 0.0
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital Descr. of Functions HLA Module (FBHLA) – 04.00 Edition
0...7 index of the parameter set
Minimum: Maximum:
0.05 1.0
Input of damping for control output filter 1 (PT2 low-pass).
0...7 index of the parameter set
Minimum: Maximum:
1.0 7999.0
Input of blocking frequency for control output filter 1 (bandstop)
0...7 index of the parameter set
Minimum: Maximum:
5.0 7999.0
Input of –3dB bandwidth for control output filter 1 (bandstop).
0...7 index of the parameter set
Minimum: Maximum:
0.0 7999.0
Input of numerator bandwidth for control output filter 1 (damped bandstop).
Setting a value of 0 initializes the filter as an undamped band-stop. The value
set in MD 5290 must not exceed twice the value set in MD 5289.
4 Firmware Drive Functions
4.5 Output of manipulated variables
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
FLOAT Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
FLOAT Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
FLOAT Immediately
Cross ref.: –
Relevant for: Protection level:
HLA 3/3
Data type: Effective:
FLOAT Immediately
4-131