Huawei FusionModule 1000A40 Maintenance Manual page 37

Hide thumbs Also See for FusionModule 1000A40:
Table of Contents

Advertisement

FusionModule1000A40 IT Solution
Maintenance Guide (2016.05, AI Version)
Item
Input and
output
connectors
on the
control
board inside
the electric
control box
Input and
output
cables of
the main
control
board inside
the electric
control box
Dust inside
the electric
control box
Aging of
components
inside the
electric
control box
Contactors
inside the
electric
control box
Issue 04 (2018-01-05)
Method
Expected Result
Check that input
Input and output
and output
connectors of the
connectors
control board are
between the main
in good contact.
control board and
the display panel
and between the
main control board
and T/H sensor
board are in good
contact.
Check that input
Input and output
and output cables
cables are
of the main control
securely
board are properly
connected to the
connected to each
main control
contactor, solenoid
board.
valve, high
pressure switch,
low pressure
switch,
temperature
switch, and electric
heater temperature
protection circuit
breaker.
Check the
Electrical
electrical
components,
components,
control
control
components,
components, SPDs,
SPDs, and voltage
and voltage
detection boards
detection boards.
are not dusty.
Check the surfaces
The control board,
of the control
display panel, T/H
board, display
sensor, and surge
panel, T/H sensor,
protection and
and surge
voltage detection
protection and
board are not
voltage detection
aging on the
boards.
surface.
Check the open
Contactors work
and close status of
properly.
contactors.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Maintenance
Troubleshooting
If a connector is in poor contact,
insert it securely.
If an input or output cable of the
main control board is not
properly connected, reconnect
the cable terminal.
If there is dust, use a brush or
compressed dry air to remove
dust from various electrical
components, control
components, SPDs, and voltage
detection boards.
If a board has aged, replace it.
If a contactor does not open or
close smoothly, replace it.
29

Advertisement

Table of Contents
loading

Table of Contents