Expanding the OperatorInterface (BE1)
6 Custom Operating Area
These softkeys are configured in file custom.com (like the standard version of
aeditor.com supplied) as described below.
In HMI Embedded, references must be made in file common.com (access file on
the NC for Expand user interface) to custom.com for the customer start softkeys.
Common.com is supplied so that all CUSTOM operating area softkeys are linked to
custom.com.
6.3 Response to operating area changeover
When you change from the CUSTOM operating area to another operating area and
back again, the window, which was active when you closed the CUSTOM
operating area, reappears the next time you open it.
BE1/6-150
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005