Comic.nsk; Dino.ini - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
; Mode for Undo/Redo handling (synchronization with application):
; UndoHandling=0 Automatic: Application responds immediately to Ctrl+Z, CTRL+Y,
;
; UndoHandling=1 Active application is informed that Ctrl+Z, CTRL+Y has been
;
; UndoHandling=2 No Undo/Redo function
UndoHandling=0
; Also applies to NC files
; EnableUndoOnNc=1
; EnableUndoOnNc=0
EnableUndoOnNc=0
[STEPS]
; maximum number of blocks to search for a step, 0 == no limit
MaxNrOfBlocks=1500
[ACCESSLEVEL]
GlobalReplace=6
SettingHiddenCheck=7
Enable_Simulation=7

2.5.2 COMIC.NSK

REM ----- TYPICAL COMIC START
REM CHANNEL 1
TOPIC(machineswitch) COMIC_START("COMIC001MachineSwitch
",/Channel/Configuration/mmcCmd[u1],/Channel/Configuration/mmcCmdQuit[u1])
REM CHANNEL 2
TOPIC(machineswitch) COMIC_START("COMIC002MachineSwitch
",/Channel/Configuration/mmcCmd[u2],/Channel/Configuration/mmcCmdQuit[u2])

2.5.3 DINO.INI

[ACCESSLEVEL]
USER=3
PROGRAMMER=4
[Function]
IM4/2-82
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
Default
actuated, response depends on application
NC file is also processed with Undo/Redo
With this mode it takes longer to prepare the NC file for
processing in the HMI.
NC file is not processed with Undo/Redo
; (Default)
; Protection level for softkey simulation in editor
; Read authorization for series setup
; Customer password (default)
; Setup authorization for series setup
; corresponds to keyswitch 3 (default)
; 0 : ISO-formatted paper tape is not supported
; 1 : ISO-formatted paper tape is supported
© Siemens AG, 2005. All rights reserved
08/2005