Siemens SINUMERIK 840D sl Commissioning Manual page 195

08/2005
Name
$MN_MAX_CUTTING
_EDGE_PER_TOOL
$MN_MAX_
SUMCORR_PERCUT
TING_EDGE
$MN_MM_KIND_OF_
SUMCORR
$MN_MM_NUM_CC_
MAGAZINE_PARAM
$MN_MM_NUM_CC_
MAGLOC_PARAM
$MN_MM_NUM_CC_
MON_PARAM
$MN_MM_NUM_GLO
BAL_BASE_FRAMES
$MN_MM_NUM_
SUMCORR
$MN_MM_NUM_
TOOL_ADAPTER
$MN_MM_TOOL_MA
NAGEMENT_MASK
$P_UBFR[ x ,MI]
$P_UBFR[x,RT]
$P_UBFR[x,SC]
$P_UBFR[x,SI]
$P_UBFR[x,TR]
$P_CHBFRMASK
$P_EG_BC[a]
$P_NCBFRMASK
$P_OFFN
$P_PFRAME [x,TR]
$P_ACTFRAME
$P_IFRAME
$P_TOOL
$P_TOOLL[1]
$P_TOOLL[2]
$P_TOOLL[3]
$P_TOOLND[x]
$P_TOOLNO
$P_TOOLR
$P_UIFR[x,y,MI]
$P_UIFR[x,y,RT]
$P_UIFR[x,y,SC]
$P_UIFR[x,y,SI]
$P_UIFR[x,y,TR]
$P_UIFRNUM
$R[x]
$SC_PA_ACTIV_
IMMED[x]
$SC_PA_CENT_ABS
[x,0]
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
Index Description
Max. number of edges per tool
Max. number of total offsets per tool
Properties of total offsets in NCK
No. of MagAnwdat (magazine user data) parameters
for one tool magazine
Number of Mag-Anwdat (magazine user data
parameters) per tool magazine location
No. of monitor. user data parameters for tool edge
Number of channel-independent basic frames
Total number of total offsets in NCK
Max. no. available tool adapter data sets
Settings NCK tool management
x=FrameNo Mirroring of settable frame
x=FrameNo Rotation of settable frame
x=FrameNo Scaling factor of settable frame
x=FrameNo Fine offset for frames
x=FrameNo Translation of settable frame
Active channel-specific basic frames
EG block change criterion
Active channel-independent basic frames
Offset normal
Or Compilation of active frame
Or
Number of active tool edge
Active tool length 1
Active tool length 2
Active tool length 3
x=ToolNo Number of cutting edges
Number of active tool
Active tool radius
x=FrameNo, y=Axis Mirroring of settable frame
x=FrameNo, y=Axis Rotation of settable frame
x=FrameNo, y=Axis Scaling factor of settable frame
x=FrameNo, y=Axis Fine offset for frames
x=FrameNo, y=Axis Translation of settable frame
Index of active set frame
x=ParameterNo R parameters
x=Number Immediately active after referencing
protection zone
x=Number Abscissa of arc center of 1st contour element
protection zone
Expanding the Operator Interface (BE1)
8 Terms, Tables, Lists, Examples
BE1/8-189