Siemens SINUMERIK 840D sl Commissioning Manual page 481

08/2005
30=CondWait.bmp
31=CondWait.bmp
32=CondStop.bmp
33=CondWait.bmp
34=CondWait.bmp
35=CondWait.bmp
36=CondWait.bmp
37=CondWait.bmp
38=CondWait.bmp
39=CondWait.bmp
40=CondWait.bmp
41=CondWait.bmp
42=CondWait.bmp
43=CondWait.bmp
44=CondWait.bmp
45=CondStop.bmp
46=CondWait.bmp
47=CondWait.bmp
48=CondWait.bmp
49=CondWait.bmp
50=CondWait.bmp
51=CondWait.bmp
52=CondWait.bmp
53=CondWait.bmp
54=CondWait.bmp
55=CondWait.bmp
56=CondWait.bmp
57=CondWait.bmp
58=CondWait.bmp
59=CondWait.bmp
60=CondWait.bmp
61=CondWait.bmp
62=CondWait.bmp
63=CondWait.bmp
64=CondWait.bmp
65=CondWait.bmp
[Pos1]
ChanStatFeedStopSpindleStop = 1
Spindles = 1,2
[Pos3]
SpindStat = 1
;ChanStatFeedStop = 3
[Pos5]
ChanStat = 2
;SpindStat = 3
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
;Waiting for safe operation
;No channel ready
;Oscillation active
;Axis replacement active (block change inhibited
because axis replacement in progress)
;Axis container rotation
;AXCT: following axis active
;AXCT: leading axis active
;AXCT: follow up mode active
;AXCT: internal status change
;AXCT: Axis/spindle disable
;AXCT: Corr. motion active
;Axis container replacement: Superimposed motion
;AXCT: Axis replacement active
;AXCT axis interpolator active
;Waiting for compile cycle
;Access to system variable
;Search target found (;block search has found
search target and the NCK has stopped)
;Rapid return started
;AXCT: Waiting for spindle stop
;Axis container exchange
;Machine data matching (;New config)
;Axis replacement: axis in coupling
;Axis replacement: Liftfast active
;Axis replacement: New-Config active
;Axis replacement: AXCTSW active
;Axis replacement: Waitp active
;Axis in another channel
;Axis replacement: axis PLC axis
;Axis replacement: axis reciprocating axis
;Axis replacement: axis jog axis
;Axis replacement: command axis
;Axis replacement: axis OEM axis
;coupled following axis
;coupled following axis
;coupled slave axis
;HOLD at cycle end M0
;HOLD at cycle end M1
;Wait: Axis is at limit stop
;Channel status of channel 1 is displayed,
superimposed
;by feed disable for channel 1 and spindle disable
;for spindles 1 and 2
;Spindle status for spindle 1
;Channel status of channel 3 is displayed, superimposed
;with feed disable for channel 3
;Channel status for channel 2 is displayed
;Spindle status for spindle 3 is displayed
Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
IM4/2-87