Restart - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning cnc part 2 (hmi)

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Menu for saving data

The selected system data file is saved to the CompactFlash card (optional) or can

be exported to a USB device (under development).

Press 'L' to save exception data to the local compact flash card.

You can also press 'R' to reboot immediately but we recommend to first

save the data.

The following status message also appears:

Please wait - data transmission in progress.

Transmission finished

Once all the data have been transferred successfully, the following message

Transmission finished, XXXXXX bytes saved.

The exception data was saved in folder /user/sinumerik/hmi

Please send the saved information to the SINUMERIK Hotline!

Fill in subject: "HMI-Embedded exception (SW XX.XX.XX; date)"

Press 'S' to return to save menu or 'R' to reboot

Restart

The exception handler attempts an automatic restart in Restart mode.

If the NCU has not reacted after 60 seconds, you must restart it manually by

switching the power supply to the system off and then on again.

Try rebooting - in the event of no reaction after 1 minute,

please switch off/on

SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition

If you have problems you can

press key 'S' to stop transmission.

ad.support@siemens.com

Starting Up HMI Embedded (IM2)

3 Communication/Initial Requirements

Table of Contents